Eminence Legend 1058 10" Guitar Speaker

The Eminence Legend 1058 10" Guitar Speaker has a very meaty tone, but with sparkle, definition and a smooth top-end. This Eminence Legend speaker is great for blues, country and rock. High power, vintage, seamed cone tonality for guitar. It's an ideal Vintage alnico Jensen replacement speaker.

Order today with the no-risk assurance of our Total Satisfaction and Low Price Guarantees!

• Nominal Basket Diameter: 10", 254mm
  Nominal Impedance: 8 ohms
  Power Rating*: 75W
  Resonance: 97Hz
  Usable Frequency Range: 100Hz-6kHz
  Sensitivity**: 98.7
  Magnet Weight: 16 oz.
  
  Thiele & Small Parameters
  Resonant Frequency (fs): 97Hz
  DC Resistance (Re): 7.49
  Coil Inductance (Le): 0.56mH
  Mechanical Q (Qms): 17.78
  Electromagnetic Q (Qes): 1.21
  Total Q (Qts): 1.13
  Compliance Equivalent Volume (Vas): 26.4 liters / 0.9 cu. ft.
  Peak Diaphragm Displacement Volume (Vd): 0cc
  Mechanical Compliance of Suspension (Cms): 0.16mm/N
  BL Product (BL): 8.0 T-M
  Diaphragm Mass inc. Airload (Mms): 17 grams
  Efficiency Bandwidth Product (EBP): 80
  Maximum Linear Excursion (Xmax): 0.0mm
  Surface Area of Cone (Sd): 344.9 cm2
  
  Mounting Information
  Recommended Enclosure Volume:
  Sealed: Acceptable
  Vented: Acceptable
  Overall Diameter: 10.11", 256.8mm
  Baffle Hole Diameter: 9.13", 231.8mm
  Front Sealing Gasket: fitted as standard
  Rear Sealing Gasket: fitted as standard
  Mounting Holes Diameter: 0.23", 5.7mm
  Mounting Holes B.C.D.: 9.6", 243.8mm
  Depth: 4.1", 104mm
  Net Weight: 4.4 lbs., 2 kg
  Shipping Weight: 5.4 lbs., 2.5 kg
  
  Materials of Construction
  Copper voice coil
  Polyimide former
  Ferrite magnet
  Non-vented core
  Pressed steel basket
  Paper Cone
  Paper cone edge
  Solid composition felt dust cap
  
  * Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
  **The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
  Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance " LMS using 0.25" supplied microphone (software calibrated) mounted 1m from wall/baffle " 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction " Hafler P1500 Trans-Nova amplifier " 2700 cu.ft. chamber with
  fiberglass on all six surfaces (three with custom-made wedges)