Product Overview
The Lil Texas is a new member of "The Eminence Patriot Series Of Raw Frame Drivers". The Lil Texas Is a lightweight 12 inch speaker with a Texas Edge, that Features a Very Balanced Tone with Crisp Mids and Top End Bite. The Net Weight of this Speaker is 4.1 lbs and handles up to 125 Watts of Power. Recommended For Classic Rock, and Blues Country.
Product Details
Eminence Lil' Texas 12" 125W Guitar Speaker
The Eminence Lil' Texas 12" Guitar Speaker is a lightweight 12" speaker with a little Texas edge. Lil' Texas delivers a very balanced tone with crisp mids and top end bite, tight bottom end, and very American tonality. Great for classic rock, blues, and country.
Eminence recommends the Lil" Texas speaker as an alternate replacement for the Eminence Tonkerlite speaker in the Rocktron Velocity S1122 and the THD Ported 2 x 12 cabinets.
Order today with the no-risk assurance of our Total Satisfaction and Low Price Guarantees!
- Nominal Basket Diameter: 12", 304.8mm
Nominal Impedance*: 8 ohms
Power Rating**: 125W
Resonance: 90Hz
Usable Frequency Range: 70Hz-5.5kHz
Sensitivity***: 101
Magnet Weight: 4 oz.
Gap Height: 0.28", 7.2mm
Voice Coil Diameter: 2", 50.8mm
Thiele & Small Parameters
Resonant Frequency (fs): 90Hz
DC Resistance (Re): 7.2
Coil Inductance (Le): 0.42mH
Mechanical Q (Qms): 11.29
Electromagnetic Q (Qes): 0.69
Total Q (Qts): 0.65
Compliance Equivalent Volume (Vas): 43 liters / 1.53 cu. ft.
Peak Diaphragm Displacement Volume (Vd): 66cc
Mechanical Compliance of Suspension (Cms): 0.11mm/N
BL Product (BL): 12.8 T-M
Diaphragm Mass inc. Airload (Mms): 28 grams
Efficiency Bandwidth Product (EBP): 130
Maximum Linear Excursion (Xmax): 1.3mm
Mounting Information
Recommended Enclosure Volume:
Sealed: Acceptable
Vented: Acceptable
Overall Diameter: 12.03", 305.5mm
Baffle Hole Diameter: 10.95", 278.1mm
Front Sealing Gasket: fitted as standard
Rear Sealing Gasket: fitted as standard
Mounting Holes Diameter: 0.25", 6.4mm
Mounting Holes B.C.D.: 11.59", 294.3mm
Depth: 5.07", 129mm
Net Weight: 4.1 lbs., 1.9 kg
Shipping Weight: 5.8 lbs., 2.6 kg
Materials of Construction
Copper voice coil
Polyimide former
Neodymium magnet
Non-vented core
Pressed steel basket
Paper Cone
Paper cone edge
Zurette dust cap
*Please inquire about alternative impedances.
**Multiple units exceed published rating evaluated under EIA 426A noise source and test standard while in a free-air, non-temperature controlled environment.
***The average output across the usable frequency range when applying 1W/1M into the nominal impedance. Ie: 2.83V/8ohms, 4V/16ohms.
Eminence response curves are measured under the following conditions: All speakers are tested at 1w/1m using a variety of test set-ups for the appropriate impedance " LMS using 0.25" supplied microphone (software
calibrated) mounted 1m from wall/baffle " 2ft. X 2ft. baffle is built into the wall with the speaker mounted flush against a steel ring for minimum diffraction " Hafler P1500 Trans-Nova amplifier " 2700 cu.ft. chamber with
fiberglass on all six surfaces (three with custom-made wedges)