Shure ULXP24D/58 Dual Handheld Wireless Microphone System

The Shure ULXP24D/58 Wireless Microphone System includes two ULXP4 Diversity Receivers, and two ULX2 Handheld Transmitter fitted SM58 Handheld Microphone capsules. Shure ULX Standard UHF systems represent a breakthrough in performance and price for both working musicians and professional sound installers. ULX Professional systems offer more advanced features and controls, including lockable settings and group scan function. Over 1400 selectable, pre-programmed frequencies are available, and Automatic Frequency Selection provides a straight shot to a clear channel.

ULXP4 Wireless Diversity Receiver

The expanded feature set of the ULXP4 wireless receiver, with advanced settings and controls including lockable settings and group scan, offers a direct path to full, clear audio signals. The ULXP4 offers an exceptional value in both performance and price, for both working musicians and sound installers.

ULX2 Handheld Transmitter

The ULX2 Handheld Transmitter features 3-segment battery fuel gauge, frequency and power settings, and control lockout. A backlit LCD shows group and channel.

SM58 Vocal Microphone

The Shure SM58 unidirectional (cardioid) dynamic vocal microphone is designed for professional vocal use in live performance, sound reinforcement, and studio recording. It has a tailored vocal response tuned to accentuate the warmth and clarity of lead and back-up vocals. A highly effective, built-in spherical_filter minimizes wind and breath "pop" noise. A cardioid pickup pattern isolates the main sound source while minimizing unwanted background noise. Rugged construction, a proven shock-mount system, and a steel mesh grille ensure that even with rough handling, the Shure SM58 will perform consistently, outdoors or indoors. Consistently the first choice of performers everywhere.

Order today with the no-risk assurance of our Total Satisfaction and Low Price Guarantees!

• RF Carrier Frequency Range: 554.000 to 865.000 MHz (Available frequencies depend on the applicable regulations in the country where the system is
  used). Refer to the frequency supplement supplied with the system.
  Effective Range: 100 m (300 ft.) under optimal conditions (NOTE: Actual working range depends on RF signal absorption, reflection, and interference)
  Audio Frequency Response: 25 to 15,000 Hz, ± 2dB (NOTE: Overall system frequency response depends on the microphone element.)
  
  ULXP4 Receiver Input
  Connector: Antenna Power Input
  Connector Type: BNC IEC 320
  Actual Impedance: 50 Ohms
  Nominal Input Level: —95 to —30 dBm 15 VDC
  Maximum Input Level: +6 dBm (—20 dBm recommended) 18 Vdc
  Pin Assignments: Shell = Ground Center = Signal IEC Standard
  Voltage for Remote Power: 12 Vdc, 150 mA maximum
  
  ULXP4 Receiver Output
  Connector: High Z Audio; Low Z Audio
  Output Configuration: High Z Audio Unbalanced (1/4 in.); Low Z Audio Balanced (XLR)
  Actual Impedance: High Z Audio 3 k0hms; Low Z Audio 22
  Nominal Input Level: High Z Audio Pin Assignments: Tip = Hot Ring/ Sleeve = Gnd: Low Z Audio 1 = Ground 2 = Hot 3 = Cold
  Voltage/Current/Phantom: Power Protection?: High Z Audio; Yes Low Z Audio Yes
  
  ULX2 Transmitter Input
  Input Configuration: Unbalanced, active
  Actual Impedance: 20 kohms
  Maximum Input Level: 10 Vp—p (12 dBV) for 1% THD at minimum gain setting using 1 kHz signal.
  
  ULX2 Transmitter Output
  Actual Impedance: 50 Ohms
  Nominal Output Level: 20 mW
  Maximum Output Level: 30 mW
  Pin Assignments: Shell = Ground Center = Signal
  
  Transmitter Audio Polarity: Positive pressure on microphone diaphragm (or positive voltage applied to tip of WA302 phone plug) produces positive
  voltage on pin 2 (with respect to pin 3 of low impedance output) and the tip of the high impedance 1/4-inch output
  Transmitter Gain Adjustment Range: ULX1: 25 dB
  Receiver Audio Output Level (± 38 kHz deviation, 1 kHz tone):
  XLR connector (into 600 ohm load): +3.9 dBV (line), —17 dBV (mic)
  1/4 inch connector (into 3000 ohm load): —2 dBV
  Impedance
  ULX2 (input): 1 Megohm ULXP4 (output): 50 ohms at line level; 2000 ohms at mic level
  Modulation: ±38 kHz deviation compressor-expander system with pre- and de-emphasis.
  RF Power Output: ULX2: 30 mW maximum
  Dynamic Range: >100 dB, A-weighted
  RF Sensitivity: 1.26 uV for 12 dB SINAD (typical)
  Image Rejection: 80 dB typical
  Spurious Rejection: 75 dB typical
  Ultimate Quieting (reference ± 38 kHz deviation): >105 dB, A-weighted
  System Distortion (reference ± 38 kHz deviation, 1 kHz modulation): 0.3% total harmonic distortion, typical
  Power Requirements: ULX2: 9V alkaline battery; 8.4 V Nicad optional; ULXS4: 14 - 18 Vdc (negative ground), 550 mA
  Battery Life: 8 to 9 hours (with 9V alkaline battery)
  Operating Temperature Range: - 20 degrees to 49 degrees C (- 4 degrees to 120 degrees F)
  NOTE: Battery characteristics may limit this range
  NOTE: Bodypack and Handheld Transmitters cannot be used simultaneously
  
  ULXP4 Dimensions (H x W x D): 1.72 in. x 8.56 in. x 6.88 in. (43 mm x 214 mm x 172 mm)
  ULXP4 Weight: 2 lbs 7 oz. (1105 g)
  
  ULX2/SM58 Dimensions (Length x diameter): 9 x 2 in. (228.6 x 51 mm)
  ULX2/SM58 Weight 10.2 oz. (289 g) without battery
  
  SM58 Vocal Microphone
  Type: Dynamic (moving coil)
  Frequency Response: 50 to 15,000 Hz
  Polar Pattern: Unidirectional (cardioid), rotationally symmetrical about microphone axis, uniform with frequency
  Sensitivity (at 1,000 Hz Open Circuit Voltage): -54.5 dBV/Pa (1.85 mV)
  1 Pa = 94 dB SPL
  Impedance: Rated impedance is 150 ohms (300 ohms actual) for connection to microphone inputs rated low impedance
  Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 with respect to pin 3
  Connector: Three-pin professional audio connector (male XLR type)