Item #1145977 Model #1022-ZDT

Earthworks 1022 2-Channel Zero Distortion Technology Preamp Standard

$2,199.00

Availability
Delivery
Out of stock
Pickup In-Store

This item is backordered but it is available to reserve now. You will not be charged until the item ships.

Email me when in stock

Save to Wishlist

Zero-distortion preamp.

The Earthworks Audio 1022 2-Channel Zero Distortion Preamplifier is based on discrete circuitry designed by David Blackmer. It establishes a new standard of sonic excellence in electronics. This exacting new standard provides frequency response range of 1Hz–200kHz +0.5dB, a rise time of 0.27 microseconds and distortion of less than one part per million (0.0001%), eliminating all possibility of sonic degradation. Like the other preamps in the ZDT Series, the 1022 2-channel preamp is so fast, so clean and so transparent that you don’t even know it’s there. You will hear clarity and detail with the ZDT preamps that is not available in any other preamp at any price.

Specifications
  • Preamp Type: Solid State
  • Number of Channels: 2
  • Frequency Response: 2Hz to 100kHz ±0.1dB, 1Hz to 200kHz ±0.5dB
  • Impulse Response: 1.4µs
  • Distortion: XLR out: less than 1ppm (0.0001%); 1/4” out: 0.001%
  • Input Noise: 1.6nVHz½ at 20dB gain; 0.6nV/Hz½ at 60dB gain
  • EIN: -132dBV at 20dB gain; -143dBV at 60dB gain
  • Slew Rate: 22V/µs
  • Output DC Offset: ±1 mV typical, servo balanced
  • Power Requirement: 120V AC (100V and 200-240V versions available)
  • Input: 2 XLR Female balanced transformerless
  • Input Impedance: 10KΩ phantom on, 100KΩ phantom off
  • Outputs: 2 XLR Male balanced transformerless (stepped)
  • 2 ¼” TRS XLR Fem. balanced transformerless (variable)
  • Dimensions: 1 rack space 1.75” x 19” x 10.375”
  • Weight: 6 lb. (2.7kg)

Features

  • Zero Distortion – less than one part per million
  • High output level +30dBu
  • Very low output impedance will drive long lines without interference or signal loss
  • True 48 volt phantom, polarity reverse & clip indicator
  • Separate XLR & 1/4” Phone (t-r-s) outputs, each with its own gain/level controls
  • 1/4” phone connector output will drive balanced or unbalanced inputs
  • Full differential (balanced) from XLR in to XLR out – no internal conversion to single-ended
  • All discrete components; Class A amplification (no ICs in the signal path)
  • Greater transparency with minimum signal path and minimum features